vision trimline 1053, Installation Instructions Manual, Page: 16 / 115

Page.14
No ACTION Possible problem/cause Solution
1.
Option: wall switch START:
press ON button > wall switch
works.
NO
Bent pin on switch, or cable
not operating properly.
Straighten pin, replace wall
switch or cable.
1. Manual transmitter START:
press both buttons to start
ignition sequence.
Beep will occur each second
NO Manual transmitter battery
low.
Replace battery, 2x AAA 1.5V
quality alkaline!
Receiver batteries low. Replace batteries, 2x AA 1.5V
quality alkaline!
Optional mains adapter not
operating properly.
Check mains adapter.
Check coding of transmitter
and receiver.
Learn in new code, see
instructions and label on
receiver.
OK Transmitter/receiver range
limited.
1. Move antenna cable,
see instructions.
2. Replace receiver.
Optional wall switch / cabling
not operating properly.
Replace wall switch / cabling.
Receiver fuse blown (in older
versions only).
Replace receiver.
2.
Magnet unit in gas valve is
energised (audible click)
NO
No beep Impulse magnet not
operating properly.
Replace gas valve.
NO
3 short
beeps
Receiver batteries low. Replace batteries, 4x 1.5V AA
quality alkaline!
NO
1 long beep ON/OFF switch on gas valve
in OFF position
Set switch to ON.
8-wire cable between receiver
and gas valve defective /
poor contact.
Check cable, especially in case
of plug connection.
OK Switch cable disconnected. Check switch cable, see fig. 1
on page 18
Motor not operating properly. Replace gas valve.
Micro switch on gas valve not
operating properly.
Replace gas valve.
11. TROUBLESHOOTING LIST MERTIK GV60