Vision Fitness T600, Instructions Manual

Page: 6 / 18

6
ENGLISH
2
A
1
2
4
5
6
8
7
9
3
B
C
E
F
10
1
Hardware For Step 1
Description Qty
A
B
C
Pre-installed Screw
Bolt
Flat Washer
2
8
8
IMPORTANT: Do not tighten bolts until step 3 is complete.
•
Remove 2 pre-installed screws (A) and detach MOTOR COVER (1).
• Open
HARDWARE FOR STEP 1.
• Attach LEFT CONSOLE MAST (3) to BASE FRAME (2) using 4 BOLTS (B)
and 4 FLAT WASHERS (C) from the top and bottom.
• Attach LEAD WIRE (4) to CONSOLE CABLE (5) and pull lead wire through
RIGHT CONSOLE MAST (6). After pulling the lead wire through the mast,
the top of the console cable should be located at the top of the mast.
Detach and discard lead wire.
• Attach RIGHT CONSOLE MAST (6) to BASE FRAME (2) using 4 BOLTS (B)
and 4 FLAT WASHERS (C) from the top and bottom.
NOTE: Be careful not to pinch wires while attaching the handlebar.
Hardware For Step 2
Description Qty
E
F
Bolt
Arc Washer
4
4
• Open HARDWARE FOR STEP 2.
• Connect the HEART RATE GRIP WIRE (7), discard the wire tie, and tuck the cables
inside the LEFT HANDLE BAR (8) and slide into the CONSOLE BASE (9).
• Connect the HEART RATE GRIP WIRE (7), discard the wire tie, and tuck the cables
inside the RIGHT HANDLE BAR (10) and slide into the CONSOLE BASE (9).
• Attach HANDLEBARS (8 & 10) to CONSOLE BASE (9) using 4 BOLTS (E) and 4
CURVED WASHERS (F).