VISIOMED BABY humidoo XL VM-H2, Manual

Page: 10 / 38

18 19
V. CLEANING AND MAINTENANCE
Depending on the hardness of your water and the use of essential oils, scale may form
on the membrane of the tank. This can disrupt the ultrasound system and vibrations
of the appliance.
To avoid problems, we advise you to look after your HumidooXL
©
by following these
steps :
FREQUENCY : Every 5 or 6 uses or every 2 or 3 days of use :
1. Disconnect the appliance and remove the cover.
2. Drain the tank.
3. Disconnect the AC adapter from the appliance (see under the appliance).
4. Put a tablespoon of citric acid (lemon juice) and 100 ml of hot water (temperature
above 70°C) in the tank. You can also replace the lemon juice with 4 tablespoons of
white vinegar in 100 ml of hot water.
5. Leave it to work for 5 minutes and empty the tank once again.
6. Dry the tank with a dry cloth without touching the membrane.
ATTENTION
• Do not dry the membrane with a dry cloth, because this can damage it.
• Do not use other acids, enzymes or detergents to clean the air humidifier. This may
give off toxic gas or cause malfunctions.
• Never clean the appliance when it is running or connected to the mains. Be sure to
disconnect the device during cleaning.
Frequently asked questions :
• What product can be used to clean the air humidifier membrane ?
A: Mild detergent (without solvent or abrasive), slightly acidic detergent (1 to 3 drops,
diluted in 100 ml of water), white vinegar or citric acid (lemon juice).
• What must I do if my water is very hard ? If scale builds up ?
A: If you find scale on the membrane, we advise you to clean it with a cotton swab,
moistened with one of cleaning products recommended in this manual. If your
water is very hard, we advise you to clean your appliance more regularly, so you do
not allow it to become scaled.
• What product should not be used for cleaning the membrane ?
A: NEVER use abrasive product (scouring cream, baking soda, etc.), solvents (90° alco-
hol, bleach, ammonia, etc.).
VI. TECHNICAL CHARACTERISTICS
• Dimensions : Approx. 168 x 121 mm
• Weight : Approx. 520 g
• Power supply : Input / Output : 100-240 V +/- 50 or 60 Hz / 24 V = 650 mA
• Length of cable : Approx. 170 cm
• Absorbed power : Approx. 13 W
• Timer Mode : 60/120/180 min/continuous
• Water tank capacity : 500 ml
• LED light : 9 bulbs
• Materials : Top parts in PP, base in ABS
• Accessories : AC adapter and graduated container
• Misting method : Vibrations by ultrasound at approximately 2.4 MHz
STEAM
OUTPUT