Visio-tek Wi-
Fi Microscope User’s Manual
page 15
9.
In the live video window click on the calibration button
,
and then click and extend to a specific length; a small window
will pop up.
10.
Enter the actual length (in the example, 2mm) and click the “OK”
button.
The software will automatically calibrate the scale of magnification,
which will show on the right-hand box of the calibration button.
The calibration is complete; you can now mark accurate
measurements on photos or real-time video at this focus level.
(Please, do not
adjust the “Focus & Magnification Wheel”
).
If the new object is not in focus, please only adjust the distance
between the microscope and the object until the image becomes
clear, and then take the photo and make the necessary
measurements.
5.4
Measurement on Windows Systems
Line measurement
Allows you to measure the linear distance between two points. Simply
click and drag to the desired length, and click again to finish.
Point to Line Measurement
Allows measurement of a line 90 degrees from a certain line. Simply
create a line to represent the base by clicking once to start, drag, and
then click again to set the endpoint. Branch off from the base line to start
measuring the line that is 90 degrees from the base line and make a final
click to finish the measurement.
Continuous Line Measurement
Allows measurement of the distance between multiple connecting lines.
Simply click and drag to form one section of distance, click again to start
another section. Continue until the total desired distance is measured.
Double-click to finish.
Polygon Measurement
Allows measurement of a polygon. Simply click and drag to form the
desired length, and click again to start the next section, double-click to
finish the polygon measurement.
Radius of Circle Measurement
Allows you to measure the circumference, area, and radius of a circle.
Simply click and extend out to the desired radius.
Diameter of Circle Measurement
Allows you to measure the circumference, area, and radius of a circle.
Simply click and extend out to the desired diameter.
