Get to know your new VISIO 24
13
Now switch on VISIO 24 to use it.
The
control unit
is located directly in the middle under the screen. The
on-
switch
is on the far left. Press the power button for about a second to turn on the
device. As soon as the lights come on, you can let go of the switch. The monitor
may display the message like "out of range ..." until you see the enlarged original
on the screen after a few seconds.
To switch off VISIO 24, you have to press the on switch for longer than a second.
This prevents you from switching off the VISIO 24 by accidentally briefly touching
the switch. Practice turning it on and off a few times, then leave it on for the next
few steps.
Place a template on the
XY-table
. Take something colored, maybe a brochure or
magazine with text and colored pictures.
To align the template exactly horizontally, push it back against the silver rear
edge of the XY-table. If you now slide the XY-table from left to right, you will not
slip in the line, as the template aligns itself on the edge parallel to the guide direc-
tion. This little trick will make your reading a lot easier.
The XY-table has a brake for locking. You will find the brake lever on the front
edge of the XY-table. Move the lever all the way to the left to be able to move the
XY-table freely in all directions. With the lever in the middle position, you can
move the XY-table slightly to the right and left; the movement to the front and
back is blocked. In the rightmost position, the table is firmly locked in all direc-
tions.
Now align your template with the rear edge of the XY-table and move the brake
lever all the way to the left.
Attention:
Avoid getting your fingers or clothing into the mechanics of the
XY-table below the reading plate to prevent them from being trapped. Keep your
hands above the plate or on the front edge. Do not reach under the side or rear
edges of the reading plate.
Now let's try the buttons on the control unit. You already know the on-switch on
the far left of the control unit.
