Issue February 2002
Document Number: 13124
- 19 -
6. Parameter: setting and display
The parameter can be set in two different ways:
•
at the Controller and
•
with a PC via the serial interface of the Controller.
6.1. Parameter in the main menu
In the following text, the keys to be activated are marked black..
Example: means that the key
IN
shall be pressed. The display
- - - -
symbolizes an
identified keyboard operation, no further keyboard operation is necessary.
The target power factor and the switching delay time can be modified directly by means of the main
menu.
By means of the key the respective menu point can be selected.
The values can be reduced by means of the key
or can be increased by means of
the key
The selected value is stored via the key
6.2. Parameters in the setting menu
6.2.1. Setting menu - call-in
In a specific setting menu, another 19 parameters can be modified. This menu
can be activated by
simultaneous
pressing of the keys
The keys must be kept pressed until the display shows the value
8888
after about 5 seconds.
Thereafter, the parameter
- 1-
and in alternation its actual occupancy, e.g.:
AU1
, is shown.
A parameter can be selected by pressing key or
6.2.2. Setting menu – Modifying the parameter
If the parameter is to be modified, press key The set value flashes in the
display.
The value can be modified by pressing the keys
or