41
User Guide
Viscount
Sonus 60
/
60
Dlx
-
45
/
45
Dlx
-
40
/
40
Dlx
1. PEDAL Section.
Contains the pedal’s stops and couplers for linking the manuals to the pedal board.
2. MAN.I Section.
Stops, manual couplers and tremulants for Manual I.
3. MAN.II Section.
Manual II stops, couplers (in the
60 / 60 Dlx
) and tremulants.
4. MAN.III Section.
Manual III stops and tremulants.
In these sections it is possible to play one or two orchestral voices. To do so the desired sound has to be
enabled through the “Alternative voice” function (see par. 8.3). The list of the stops that can play orchestra
voices changes according to the “tonal layout” implemented in the organ. A web page were you can get info
about your specific model is at your disposal at www.physisorgans.com/download.asp.
5. Instrument on/off switch.
6. Control and programming section.
Contains the buttons and display for viewing and programming all the instrument’s setup and sequencer
functions.
7. MIDI Section
These controls, provided for each manual and the pedal board, allow transmission of the note MIDI
codes on the MIDI [OUT] port to be enabled and disabled. All the instrument’s other MIDI messages
will continue to be transmitted, even with the MIDI control off.
8. Additional displays.
-
[CRESCENDO] (
60 / 60 Dlx
only): shows the step currently reached by the [CRESCENDO] pedal
(point 14)
-
[M. BANK]: displays the memory bank of the combinations (general and customised) selected using
the [MEM. BANK +] and [MEM. BANK -] pistons (point 11).
9. General pistons.
These pistons recall the general combinations of the memory bank selected using [MEM. BANK +] and
[MEM. BANK -] (point 11). These combinations can be modified; the procedure for saving them is
described in point 10.
[HR] restores the voice setup prepared in manual mode before a memory was recalled.
General combination sequencer controls are also provided, [PREV] in descending order, [NEXT.] in
ascending order.
10. [S] piston.
Fixing piston for saving the general and dedicated combinations, the Tutti and the Crescendo steps.
To set a combination or the Tutti, after setting the voices as required, press [S], hold it down and then
press the piston of the combinations you wish to save.
To save a Crescendo step, select it using the pedal of the same name, press [S], hold it down and press the
[HR] of the general memories. To copy the contents of one step into another, select the step you wish to
copy, hold down the [S] piston, select the step into which you wish to copy the contents, then press the
[HR] of the general memories.
NOTE
If the LED of the [S] piston is off, programming of the organ is locked out by the Lock Organ function
(chapt. 10), so it will not be possible to save combinations and/or view internal programming functions.
