55
User Guide
Viscount
Sonus 60
/
60
Dlx
-
45
/
45
Dlx
-
40
/
40
Dlx
Functioning of different modes is described in the tables below.
Organs equipped with 4 audio outputs:
MODE
OUTPUTS 1-2
OUTPUTS 3-4
STANDARD
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
GENERAL-REVERB
General signal
Reverberated signal only
Organs equipped with the expansion kit for 12 audio outputs:
NOTE
In the models equipped with 4 audio outputs, it is not possible to configure the registers output
router in the EXTERNAL OUT ROUTER function selecting the REVERB outputs mode.
MODE
OUTPUTS 1-8
OUTPUTS 9-10
OUTPUTS 11-12
TAB AMPLIFICAT.
[CONSOLE ON]
TAB AMPLIFICAT.
[EXT. SPEAKER ON]
STANDARD
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
Internal amplification
Outputs 1-12
GENERAL-REVERB
As set in Ext. Router
Conf. function.
General signal
Reverberated signal only
Outputs 1-8
Outputs 9-12
ANTIPHONAL
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
Outputs 1-8
Outputs 9-12
GENERAL-ANTIPH.
As set in Ext. Router
Conf. function.
General signal
As set in Ext. Router
Conf. function.
Outputs 1-8
Outputs 9-12
ANTIPH.-REVERB
As set in Ext. Router
Conf. function.
As set in Ext. Router
Conf. function.
Reverberated signal only
Outputs 1-8
Outputs 9-12
9.2 CONFIGURING THE AUDIO OUTPUTS ON THE REAR
(EXT. OUT CONFIG function)
Thanks to this function, the PROGRAMMABLE OUTPUTS can be configured, so as to manage the
Antiphonal signal (controlled through the AMPLIFICATION tabs), the general signal or just the reverberated
signal of the instrument. Select the EXT. OUT CONFIG. field under the SET-UP menu; this pop-up message
will appear:
which means that the external panning (see par- 9.1) of certain stops might be modified automatically.
Stops placed between outputs [2] and [3] (in organs equipped with 4 outputs) or [8] and [9] (in organs
equipped with 12 outputs), and/or outputs set as GENERAL or REVERB, will be automatically set as
Mono on the first output of the previously configured panning.
Press [EXIT] to abort the automatic panning adjustment and return to the SET-UP menu.
Press [ENTER] to confirm - the display will show: