10 / 16
plug´n´dose
4
Operation
4.1
Start-up
Set the dispenser (D) to function standby condition as described in the operation and
maintenance manual supplied.
Connect the dispenser (D) connecting cable to plug 3.
Connect the connecting cable to the master control unit (B).
Connect the connecting cable to plug 1.
Fill the dispenser with material as described in the operation and maintenance manual.
NOTE
The dispenser connecting cable (plug 3) may only be connected and disconnected when
the power supply is switched off. The electronics in the drive motor could be damaged if
this precaution is not taken.
NOTE
Only use the original enclosed connection cables between the dispenser (D) and the
plug 3. The connecting cables must not be extended or shortened. This can lead to
damage to the controller.
The dosing control unit is not ready for operation until the dispenser is connected.
Fig. 4
B
1
3
D
