Note: If you install on wood wall, make it sure that all the hole must be on
the studs! Then please go 7a. , or you need go 7b!
7a. For each location, insert a lag bolt and
washer into the wall.
8a. Tighten bolt with an open ended socket
wrench by turning clockwise until tight.
CAUTION:
Do not over-tighten bolts-doing so
may cause unnecessary damage to the wall.
Avoid excessive torque.
CAUTION:
Do not release the wall plate until it
is properly mounted and secured to the wall.
NOTE: The concrete anchors must be used for concrete or brick wall. They
can be purchased at your local hardware store.
7b. Insert a concrete anchor into each hole.
8b. If necessary, a hammer can be used to
lightly tap each anchor into place so that
they are flush with the wall.
9b. Once all of the anchors are in place,
move the wall plate back into position.
10b. Attach the nut onto the threaded shaft
that is protruding from the wall.
11b. Do not tighten until all nuts are in place.
Display Bracket Installation
. To ensure optimal installation, this
1
kit includes various screws of
3.
4.
p
st in depth to the recess to keep your
5.
6.
Fin
different diameters and lengths.
2. Place your TV screen down on a
soft, flat surface, and locate the
threaded mounting points that are
located on the back of the display.
Determine which screw is the
correct length by carefully inserting
a straw, or toothpick, and mark how
deep the mounting point is.
If your display has a curved back or
a recessed thread mounting point, a s acer must be used.
NOTE: Select the spacer that is close
bracket as close to the display as possible.
Place the spacer between the mounting bracket and the display.
If a smaller screw is being used(M4,M5 or M6), please use a washer with
each screw for added stability
al Installation
ch each bracket to the display by aligning the
Atta
holes on each bracket, with
rts on the back panel of your display, inserting the screws
the threaded inse
through both and turning clockwise until they are fully inserted.
1. Tighten with a Phillips head screw
driver.
CAUTION:
Two people are required for
this step.
2. To complete the installation of yo
new lcd/plasma mount, carefully pla
ur
ce
3.
or
security, you can install the safety-ba
ount. The safety bar can be inserted from either side of the mount. It should
ou can also attach a p
e safety-bar to
revent unwanted removal of your TV from the mount.
the television brackets over the upper
and lower mounting crossbars.
Making sure that the safety-bar is not
in place when placing the television on
the mount
additional
F
r that is included with your
m
pass through the interspace of the lower part of the two TV brackets.
Y
adlock (not included) to the end of th
p
