3.3.3. Additional Duplication Parameters
3.3.3.1. «Perform low-level erase before duplication»
«Perform low-level erase before duplication»
parameter is applicable in
«Duplicate Only»
and
«Duplicate and
Verify»
operation modes and performs low-level format prior to duplication.
«Format Mode»
specifies type of format that will be used if
«Format Slave Card Before Duplication»
is
enabled.
3.3.3.2. «Perform low-level erase after duplication»
In this mode low-level erase is performed after duplication is complete.
This mode is used in cases when testing reliability of the flash media and do not want to leave any data after
test is complete.
3.3.3.3. Number of Verification Passes
«Number of Verification Passes»
parameter is applicable in
«Duplicate and Verify»
and
«Verify Only»
operation modes and defines number of verification passes to perform. (up to 5) .
Normally one verification pass is sufficient enough to locate data transfer errors, but multiple passes can help
with flash media reliability testing.
3.3.3.4. Master-Slave Size Match Control
«Master-Slave Size Control»
menu is active in
«Duplicate Only»
and
«Duplicate and Verify»
operation modes
and defines three policies towards the sizes of master and slave drives:
-
«All sizes can differ»
- «All slaves has to be the same, master can differ»
- «Master and slaves has to be the same»
3.3.3.5. Duplicate Only Files
«Duplicate Only Files»
parameter is applicable in
«Duplicate Only»
,
«Duplicate and Verify»
operation modes
and only when master card or image file being used as a data source. In this mode only sectors that contain
actual files will be copied from data source to slave cards. Only FAT12, FAT16 or FAT32 is supported.
3.3.3.6. Auto-Start
Enabling
«Auto-Start»
parameter allows duplication process to start without pressing the Start Button.
When all 20 slave cards are inserted, duplication process starts automatically.
3.3.4. Custom Size Duplication
Very often master card contains very small amount of actual data that has to be duplicated compared to the full
size of the flash media card.
Custom size duplication allows user to duplicate only specific area of the flash card by specifying a starting
point and an offset.
User can specify units in which starting pint and offset will be measured (512 byte Blocks, Bytes, Kilobytes,
Megabytes, Gigabytes) and the actual values of starting point and offset.
User Manual
15
F l a s h C a r d / D r i v e D u p l i c a t o r
