#1: Take out the bottom case from the
packaging and insert the two aluminum
tubes into the bottom case as shown.
Tighten the screw so that the case is
tight against the tubes.
#2: Take out the drum module and three
Tom pads from the packaging and insert
them on to the two aluminum tubes as
shown and tighten the screws. Make sure
the plastic support is tighten to both the
assembly and the tubes.
#3: Take out the cymbal poles from the
packaging and insert them into the pad
holes as shown in the figure and tighten
the T-screws.
#4: Assemble Crash cymbals as shown in
the figure and tighten the T-screws.
Assembly Instruction
5
