Operation
9
2.
To initiate a manual regeneration immediately, press and hold the
REGEN
button for three seconds. The system will
begin to regenerate immediately. This command cannot be cancelled.
Once a manual regeneration is initiated, the unit will go into the “FILL” position, followed by the steps listed in
Section 3.3
.
During this initial sequence the water softener will deliver treated water.
3.2.4 Power Loss and Battery Replacement
The AC transformer comes with a 15 foot power cord and is designed for use with the control valve; the transformer should
only be used in a dry location.
In the event of a power outage, the control valve will remember all settings and time of day. If an extended power outage
occurs, the control valve will keep time of day until the battery is depleted. When the battery becomes depleted, the only
item that needs to be reset is the time of day and will be indicated by the time of day flashing. All other settings are
permanently stored in the nonvolatile memory.
If a power loss occurs and the time of day flashes, this indicates that the battery is depleted. The time of day should be
reset and the non rechargeable battery should be replaced. The battery is a 3 Volt lithium coin cell type 2032 and is readily
available at most stores. To access battery location, remove front cover, refer to
Section 5.1
.
3.2.5 Error Message
If the word “ERROR” and a number are alternately flashing on the display record the number and contact your dealer for
help. This indicates that the control valve was not able to function properly.
3.2.6 Brine Tank Maintenance and Salt
Refill the brine tank as necessary, making sure at least 1/3 of the brine tank is full at all times. Without proper salt levels, the
water softener may not operate properly.
The manufacturer recommends the use of solar salt for best results. The brine tank is manufactured for the use of solar,
pellets, rock salt or block salt. If pellet or rock salt is used, a cleaning of the brine tank every six months is recommended.
3.3 Start-up Instructions
•
After installation is complete, rotate bypass handles to bypass mode, refer to
Figure 2
.
•
Turn on water and check for leaks.
•
Fully open a cold water faucet - preferably a laundry sink or bathtub with no aerator.
•
Allow water to run until clear to rid pipes of debris which may have occurred during installation.
Note:
“REGEN TODAY” and “TIME OF DAY” will flash alternately if a regeneration is expected tonight.
Note:
When replacing the battery, align positives and push down to fully seat.
1
2