2.
Verify the internal dimensions of the rack with a tape measure. The chassis is 440 mm wide and must fit
within the mounting posts.
3.
Secure the two short mounting ears, marked Left and Right, to either side of the router chassis using the
eight screws for mounting ears (four on each side) in the packet marked B.
Figure 5: Attaching the Short Mounting Ears to the vEdge 2000 Router Chassis
1.
Slide out the two interchangeable 1U sliders, and secure to either side of the router chassis using the eight
screws for sliders (four on each side) in the packet marked D.
Figure 6: Attaching the 1U Sliders to the vEdge 2000 Router Chassis
1.
Grasp both sides of the router, then lift and position it in the rack, aligning the front bracket holes with
the threaded holes in the front post of the rack rail. Align the bottom hole in both the mounting brackets
with a hole in each rack rail, making sure the chassis is level.
vEdge 2000 Router
32
vEdge 2000 Router
Install the vEdge 2000 Router