Maintenance
March 2020
Operating guidelines AS6690T / AS7690T / AS7190TO series
When scrubbing is complete, with the deck and
squeegee raised, return to the dump/fill site. Turn
off the key to perform the following maintenance.
Daily:
Place the rear of the scrubber over a floor drain.
Empty the clean water tank using the solution tank
drain knob under the machine.
Daily:
Empty the recovery tank using the recovery
empty hose. Bend the soft part before removing
the cap to control the flow.
Daily:
Inspect and rinse the float ball cage. Inspect,
check and clean the debris tray and clean the lid
gasket if required.
Daily:
Remove the squeegee, and clean. Inspect the
blades and flip or replace them if required.
Weekly:
Inspect the solution filter and clean
if required.
Daily:
Always open the recovery tank for
battery charging.
SHELF CHARGER - Plug the connector from the
charger to the connector on the back of the machine.
Plug the charger power cord into the wall socket.
ONBOARD CHARGER: Disconnect the battery pack
from the machine connector. Plug the battery pack
connector into the charger. Plug the charger power
cord into the wall socket.
Daily:
Charge the machine at the end of the cleaning
shift or if the battery indicator is low or showing empty.
Daily:
Leave the recovery tank lid open after it’s been
cleaned to air out and avoid any odor formulation.
Local Viper dealer:
Phone number:
SN:
21809 3/2020
©2020 Nilfisk, Inc.
