©
2002
Directed Electronics, Inc.
15
2. IIggnniittiioonn.. Turn the ignition on, then back off: (The H1/9 YELLOW wire must
be connected.)
3. SSeelleecctt aa M
Meennuu.. Press and HOLD the Valet/Program switch: (The
Valet/Program switch must be plugged into the blue port.) After three seconds
the siren will chirp once indicating entry to the Basic Features Menu #1. If this
is the menu you wish to access, release the button and go on to Step 4. If the
button is not released, you will jump to the Advanced Features Menu #2 and
the siren will chirp twice. Once you have selected the desired menu, release the
Valet/Program button and then proceed to Step 4.
4. SSeelleecctt aa FFeeaattuurree.. Press and release the Valet/Program switch the number of
times corresponding to the feature you wish to change. For example, to access
the third feature, press and release the switch three times. Then press the switch
once more and HOLD it. The siren will chirp the number of times equal to
the step you have accessed.
5. PPrrooggrraam
m tthhee FFeeaattuurree.. While HOLDING the Valet/Program switch, you can
toggle the feature on and off using the remote transmitter. Pressing
will
select the one chirp setting. Pressing
will select the two chirp
setting. (See
System Features Menus
section of this guide.)
NOTE: The Valet pulse count feature (2-5) and the Channel three timed
output (2-9) have five possible settings each. Pressing
will toggle through
all the two-chirp settings.
6. R
Reelleeaassee tthhee V
Vaalleett//PPrrooggrraam
m SSw
wiittcchh..
Once a feature is programmed:
➤
➤
Other features can be programmed within the same menu.
➤
➤
Another menu can be selected.
➤
➤
The learn routine can be exited if programming is complete.
