Viper 50000569, Quick Start Manual

Page: 15 / 429

QUICK START GUIDE ENGLISH
12
BRUSH/PAD-HOLDER INSTALLATION AND REMOVAL (only for disc machine)
NOTE
Install either the brush (A, Figure 9) or pad-holder (B and C, Figure 9) according to the type of floor to be
cleaned.
CAUTION
!
Before installation or removal of brush or pad-holder, make sure all the switches on machine are in off position
and the squeegee is lifted off the floor. The operator must be equipped with suitable personnel protection de-
vices, such as gloves to reduce the risk of accidents.
Proceed as following:
INSTALLATION:
1.
Insert the ignition key (42, Figure 3) and turn it to "I". Lift the deck.
Turn off the machine by removing the ignition key(42).
2.
Turn the speed adjuster (48) to idle by turning it counter-clockwise.
3.
Place the brushes (A, Figure 9) or the pad-holder (B) under the deck.
4.
Use the manual method by turning the brush/pad-holder in the
direction opposite to the normal turning direction, and it can be
installed. (as shown in Figure 9)
REMOVAL:
1.
Insert the ignition key (42, Figure 3) and turn it to "I”. To remove the
brush/pad-holder lift the deck by pressing the Brush/pad-holder
release button (44), the brush/pad-holder will be automatically
released.
PAD INSTALLATION AND REMOVAL (only for or-
bital machine)
1.
Insert the ignition key (42, Figure 3) and turn it to "I". Lift the deck.
Turn off the machine by removing the ignition key.
2.
Use the manual method to install or remove the pad as (Figure 10)
Figure 9
Figure 10