VIPColor VP700, User Manual

Page: 77 / 81

76
Appendix
• Device B signals it is ready by pulling down the Ready signal. This must remain
low for at least 50 ms. When the Ready signal is pulled up while the printer is
printing, the printer will pause and behave exactly the same way as if the user
presses the Pause button on the control panel. The printer remains in Pause
mode until the Ready signal is pulled down again for at least 50ms.
• The printer prints and pulls up the signal when printing is completed.
• No printing occurs whenever the Printer Error signal is pulled low.
Figure 11 Timing Diagram
Table 7 GPIO Pin Assignment (D ‐ sub 9 ‐ pin Connector)
Pin Signal Description
1 HIGH (3.3 V)
2 ADC 5
3 Print job ready (output) (GPIO A25)
4 External device ready (input) (GPIO D04)
5 Printer error (output) (GPIO D08)
6 LOW (0 V)
7 NC