VIPA System 200V PC 288, Manual

Page: 43 / 54

Manual VIPA System 200V Chapter 3 PC 288 - CPU
HB97E - PC - Rev. 06/29 3-15
This sub-menu provides access to the main settings for your system.
The menu is divided into a number of logical units. You can navigate
through these by means of the cursor keys.
+------------------------------------------------------------------------------+
| |
| System Bios Setup - Basic CMOS Configuration |
| (C) 1999 General Software, Inc. All rights reserved |
+---------------------------+--------------------+-----------------------------+
| DRIVE ASSIGNMENT ORDER: | Date:>Jan 01, 2000 | Typematic Delay : 250 ms |
| Drive A: (None) | Time: 10 : 03 : 25 | Typematic Rate : 30 cps |
| Drive B: (None) | NumLock: Disabled | Seek at Boot : None |
| Drive C: CompactFlash +--------------------+ Show "Hit Del" : Enabled |
| Drive D: (None) | BOOT ORDER: | Config Box : Enabled |
| Drive E: (None) | Boot 1st: Drive C: | F1 Error Wait : Enabled |
| Drive F: (None) | Boot 2nd: (None) | Parity Checking : (Unused) |
| Drive G: (None) | Boot 3rd: (None) | Memory Test Tick : Enabled |
| Drive H: (None) | Boot 4th: (None) | Test Above 1 MB : Disabled |
| Drive I: (None) | Boot 5th: (None) | Long Memory Test : (Unused) |
| Drive J: (None) | Boot 6th: (None) | Hexadecimal Case : Upper |
| Drive K: (None) +--------------------+-----------------+-----------+
| Boot Method: Boot Sector | IDE DRIVE GEOMETRY: Sect Hds Cyls | Memory |
+---------------------------+ Ide 0: 2 = AUTOCONFIG, PHYSICAL | Base: |
| FLOPPY DRIVE TYPES: | Ide 1: Not installed | 640KB |
| Floppy 0: Not installed | Ide 2: Not installed | Ext: |
| Floppy 1: Not installed | Ide 3: Not installed | 30MB |
+---------------------------+--------------------------------------+-----------+
| U/D/L/R/<CR>/<Tab> to select |
| or <PgUp>/<PgDn>/+/+ to modify |
+------------------------------------------------------------------------------+
This section is used to assign logical drive names to the physical drives.
The VIPA BIOS only provides support for drive "C".
The following settings are valid for "C":
•
"None": if you did not insert a CompactFlash

card
•
"CompactFlash": if you have installed a CompactFlash

card.
Attention!
All the other drives must be assigned to type "None". Any other setting can
cause malfunction of the PC.
Please also note that the settings for "Ide 0" in the section
IDE Drive
Geometry must be changed at the same time as the parameters for drive
"C". The following settings are valid:
CompactFlash

DRIVE ASSIGNMENT ORDER \ Drive C: IDE DRIVE GEOMETRY \ Ide0:
Installed
CompactFlash

2 = AUTOCONFIG, PHYSICAL
Not installed None Not installed
The integrated DiskOnChip

drive (DOC) is configured by means of the
"VIPA Configuration" menu.
Basic CMOS
Configuration
Drive Assignment
Order and
IDE Drive Geometry