VK2-1080(720)BIR3V9F installation guide V2.1
8
2) Installation 2 (Using the conduit knockout in bracket base)
A. Drill the mounting location, using the template sheet (or the bottom of the mount base) as a
template.
B. Insert the plastic anchors into the drilled holes
C. Insert connection into drilled hole.
D. Secure the camera to the wall using the supplied screws
E.
Adjust the camera orientation, and fasten the mount screws (M6x16) to fix the camera.
2.2 Connection
• Connecting to the RJ-45
Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for connection
to a hub.
Micro SD memory slot on the Rear Board
Remove the rear cap of the camera to insert the SD memory card.
• Connecting the Power
Connect the power of DC12V for the network camera. C
onnect the po) pole to the ‘+’
position and the negative(-
) pole to the ‘-‘ position for the DC power.
Note: internal heater does
not operate when using PoE, the camera needs to be powered by external 12Vdc for heater
to operate.