Visit
www.vip-vision.com
for full user manual and support
19
2.3 Installation (continued)
2.3.7 Connect Power Cable (2P series) / DC Power Adaptor (2C)
For
2P Series
, connect the power cable located at the bottom left hand corner of the metal case.
For
2C Series
, plug the DC power adaptor into the power socket of the main unit.
Ignore any beep sound generated by the control panel and reader while powering up. The beep sound may last for 15
seconds when power is applied for the first time.
2.3.8 Connect Network Cable
Connect a CAT5e/CAT6 LAN cable in the NET connector of the access controller panel. Connect the other side of the
cable to the network port of a PC.
2.3.9 Connect Backup Battery (2P Series Only)
Note: A 12V sealed lead acid battery with a minimum capacity of 7AH must be used.
Connect
CON1 pin 1
to the
NEGATIVE
terminal of the battery.
Connect
CON1 pin 2
to the
POSITIVE
terminal of the battery.
Be careful with the polarity of the battery; an incorrect connection will result in
system damage.
