Operator’s Manual Page 40 of 89
OXY-2-USM-1, REV K
Also displayed on the Review screen are the following:
Viewing File: field shows the name of the file
Date: field shows the date of the data where the cursor is positioned
Time: field shows the time of the data where the cursor is positioned. Time is displayed in the current 24-hour or AM/PM format
selected from the Setup/Change time settings menus.
Elapsed Time: field shows in hours/minutes/seconds format how much time has elapsed from the start of the recording of the data to
the present cursor position..
To print a Summary Report of the data, press the top Control Bar’s
button. Refer to the Printing Data section. The Summary
Report will print the entire collection of StO
2
data values in numerical table format.
To print a Snapshot Report (Print Screen) of the data, press the
Print Screen
button. The Snapshot Report will only print the segment
of data presented on the current Review StO
2
screen.
The
Review Data
button will display the current graphed data in numerical table format. Refer to the “Reviewing StO
2
Data” section
on page 38.
If two sensors are being used, the system is in dual mode. Each channel has a
Review StO
2
button to display the StO
2
results for that channel.
Summary of Contents for T.Ox OXY-2-USM-1
