15
The alignment between amplifier and headphone is provided by the
preamp stage, which can boost or attenuate the input signal in four
steps of 6dB each. For this purpose, two switching devices are located
on the rear panel for left and right channel individually.
CAUTION !!
The switch settings should be altered under the following conditions
only:
-
The unit must be switched OFF
-
the "VOLUME" control must be set to minimum
-
left and right channel should ALWAYS be set the same
-
never increase the setting by more than ONE step per
channel at a time.
If you find your HPA V200's volume could be somewhat softer (in order
to improve volume control range e.g.), push the switch labelled "-6dB"
(half gain) or "-12dB" (quarter gain) in upward direction.
If you find your HPA V200 should provide more gain, do so with the
switch labelled "+6 dB" (double gain) or "+12 dB" (quadruple gain).
Ex-factory, all switches are set to their lowest position - i.e. 0 dB or unity
gain - which should be sufficient for most applications.
