Vinteck
TB10MKII – TB5 –True-bypass MIDI pedalboard
pag.10
Edizione 02 rev.1
DIRECT ACTIVATION OF THE 4 SWITCH
On factory preset switches are not active for direc access.
To active the switches it is necessary to programm them or to select the bottom in that way.
ACTIVATION OF A SWITCH WITHIN A PROGRAM CHANGE
When in programming mode (dots of display are on) press the buttons of a switch (1, 2, 3 or 4) and keep it
pressed for 3 seconds. The corrisponding green led will switch on (S1, S2, S3 or S4) and red led will switch off,
and loop as well.
If the loop must be active as well, shortly press button again.
Then close the programming mode with defined program button (ex 12).
PROGRAMMING OF A/B SWITCH
When in programming mode (dots of display are on) press the buttons 5 and keep it pressed for 3 seconds, The
yellow led of OUT designed will be ON. When red led of loop is ON and not necessary press again the button to
switch it off.
Press again the same program button and the memorization is completed.
If any ather buttom is pressed instead of the program used to began the programming sequence the program
will be not memorized.
S-P (SWITCHS PROGRAMMING
)
To activate the direct selection of switches with buttons press DOWN for3 seconds.
Display will show S1L.
Now is possible to select the desired switch pressing pressing the button (1, 2, 3 or 4)
Diplay will show S1L or S2L or S3L or S4L, following the selection made by switch.
Options are:
-
S1L during operative function red led will be on. Button active loop only.
-
S1S during operative function Green led on. Button active switch only
-
S1G during operative function Green and red leds on. Button active loop and switch together.
-
S1t during operative function Both leds off. Button does not active loop and switch works in one-shot
function. A very short shot on, to be used in example for tap-time or for stand-by function of instrument
whom needs this kind of segnal. Time of one-shot è di 1/10 of second. One shot function is not
memorizable in program change.
When finished the selection press again DOWN to exit.
When assign of function is done, thereis possibility to change while programming the loops combination:
-
If active function is “led red” the priorityis on loop.
-
If active function is “green red” the priorityis on loop swicth
-
If active function is both leds on no variations are allowed.
-
If active function is both leds off ( one-shot ) itis possibile to assign the loop to aprogram ch’ange, but
taptime is usable only from button, not from program ch’ange.
MIDI CHANNELS SELECTION
Selection of IN channels, out channels and set of start programchange (1-119 or 1-120) may be defined
pressing for 3 seconds button UP
The 3 parameter come following the steps of button press.
The exit of session is at fourth pression of UP button.
IN CHANNELS
Press UP for 3 seconds.
After 3 seconds will appare on display a little “i” followed by numbers:
0 = all
1-16 = channel 1 -16
Press DOWN to change in sequence the channel frrm “all” to 1 to 16.
