6
www.vintageair.com
901345 REV A 05/12/17, PG 6 OF 12
Engine Compartment Disassembly
1.
2.
3.
4.
Disconnect battery.
Remove battery (retain).
Drain radiator.
Remove the radiator mounting bolts (discard), and replace them with 1/4-20 x 1/2” hex bolts and 1/4” flat
washers.
NOTE: Before starting the installation, check the function of the vehicle (horn, lights, etc.) for proper
operation, and study the instructions, illustrations, & diagrams.
Perform the Following:
Drier Installation
1.
Insert the drier into the clamp on the passenger side condenser bracket assembly, and secure it with a 1/4”
flat washer and a 1/4-20 nut with star washer (See Photos 1, 2 and 3, below).
NOTE: Do not fully tighten
nut at this time. Refrigerant flow through drier is IN from condenser, OUT to evaporator.
Passenger Side
Condenser Bracket
Assembly
643113
Passenger Side
Condenser Bracket
Assembly
643113
1/4-20 Nut
with Star Washer
1/4”
Flat Washer
IN
Drier
Drier
1/4-20 Nut
with Star Washer
1/4”
Flat Washer
NOTE: Do not remove the caps from the drier. The drier contains a desiccant that will quickly absorb
moisture from the air, causing it to lose effectiveness. For this reason, Vintage Air recommends that
the drier remains capped until the installer is ready to evacuate the system.
Photo 1
Photo 2
Photo 3
