Vinotemp WINE-MATE WM-2500SSV, Operation Care Installation Manual

Page: 9 / 31

- 8 -
5. Manual Defrost
Press and hold the defrost
key until defrost starts. The defrost indicator will be
on.
6. Parameter Programming
1) Press and hold the SET + keys until the “ °C” or “°F” LED starts flashing,
then release the keys.
2) Press and hold again the
SET + keys until the Pr2 label is displayed, then
release the keys. The first parameter Hy will be displayed.
3) Press up/down keys / to scroll to the required parameter within 10 sec.
4) Press the “ SET ” key to display its value.
5) Use up/down keys to change its value within 10 sec.
6) Press “ SET ” to store the new value and the display will flash 3 times.
7) To exit : Press SET + or wait 15sec without pressing a key.
PARAMETER DESCRIPTION DEFAULT VALUE
Set set-point (
°
) 55
Hy
temperature regulation differential (
°
)
4
AC anti-short cycle delay (min) 10 (hidden)
Con compress on with probe faulty (min) 15
CoF compress off with probe faulty (min) 30
CF temperature unit (
° F / ° C
) F: Fahrenheit
rES display resolution in: integer
dLy temperature display delay (min) 1
ot
probe calibration (
°
)
0
LS minimum set-point (
°
) 50
US
maximum set-point (
°
)
65
idF defrost interval time (hour) 12
MdF defrost endurance time (min) 30
ALC temperature alarm type rE: relative to set-point
ALU
high temperature alarm (
°
)
10
ALL
low temperature alarm (
°
)
10
AFH alarm recovery differential (
°
) 5
ALd temperature alarm delay (min) 60
dAO temperature alarm delay on startup (hr) 23
SAA heater set-point (
°
) 40
SHy
heater regulation differential (
°
)
4
FSU fan action Std
FnC fan operating mode C-n: on with compressor & off during defrost
Fon fan on with compressor off (min) 0
FoF fan off with compressor off (min) 15
NOTE Depending on the controller, not all parameters are available