1
0
10
W W W . V I N O T E M P . C O M
WINE RACK INSTALLATION/REMOVAL
NOTE: To prevent damaging the door gasket, make sure to have the door all the way opened when
pulling shelves out of the rail compartment.
Remove any bottles stored on the racks.
Pull the racks out flatly and press the button in each side. (See figure 1)
Push the racks into sliders. (See figure 2)
REVERSAL OF DOOR SWING
The door of the wine cellar can be opened either from the left or right side. This cooler arrives
standard with the door hinge installed on the left side. If you want to reverse the direction of door
swing, please follow these instructions:
Disconnect the power, remove all wine bottles and lay the wine cellar back on the ground.
Please remember when you have finished reversing the door swing, you must refrain from
powering up the unit for 24 hours to allow the coolant to settle in the compressor.
Remove top hinge cover. Use the special screw driver to remove the three screws on the top
hinge, and then lift up the door to take the door off.
Remove the support wheel on the left bracket.
Unscrew the two screws and remove the grill.
Use the special screw driver to unscrew the six screws on the right downward door axis and
left bracket.
Install the right bracket and left downward door axis.
To transfer the door handle to the right side of the door, please follow these instructions:
o
Pull the gasket with your hand to reveal four screws (Two screws are on the upper of
door, and other two screws are on the lower of door).
o
Remove these fixing four screws on the door handle.
o
Remove the handle, and place it on the outer right side of the door.
o
Screw four screws on the interior of the door to attach the handle.
o
Reinstall the gasket onto the door.
Reinstall the door.
Install the top hinge on the other side.
Screw back in place the top hinge cover, grill and screw covers.
Install the support wheel on the right bracket.
The door is now installed on the right side.
