9
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
INSTALLATION
BEFORE USING YOUR APPLIANCE
Remove the exterior and interior packaging.
Before connecting the appliance to the power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water using a soft cloth.
Install the handle on the door.
INSTALLATION OF YOUR APPLIANCE
Use two or more people to move and install the appliance. Failure to do so can result in back or
other injury.
Place your wine cooler on a floor that is strong enough to support it when it is fully loaded.
Choose a well-ventilated area with temperatures below 90°F (32°C).
This appliance is designed for built-in, recessed or free standing installation.
For built-
in installation, leave a ¼” (6.35mm) space on each side and at the top, and 1-2” at the
back of the wine cooler to ensure proper air circulation to cool the compressor and condenser.
Also, be sure to not obstruct the front exhaust vent with anything as this may prevent the unit from
performing properly.
For freestanding installation,
5” of space at the back and both sides are suggested to ensure
proper air circulation to cool the compressor and condenser.
The appliance must be installed with all electrical, water and drain connections in accordance with
state and local codes.
Make certain that the pipes are not pinched, kinked or damaged during installation. Check for
leaks after connection.
POSITIONING YOUR WINE CELLAR
It is important for the appliance to be levelled in order to work properly. You may need to make
several adjustments to level it.
To level your appliance, adjust the front legs at the bottom of the appliance.
Important:
When using the wine cellar for the first time, allow at least 24 hours for the internal
temperature to adjust properly, Make sure there are at least 3 to 5 bottles in the unit.
NOTE:
Designed for indoor, home use only. The appliance should not be located next to sources
of high heat or in direct sunlight. Do not store or install the appliance outdoor, garage, basement or
in moist areas. Do not install in a location where the temperature will exceed 90°F (32°C). For best
performance and to ensure proper ventilation, do not install the appliance behind a cabinet door or
block the base grille.
