•
Touch
SET
once. The left LED indicator for UPPER ZONE will flash. Then touch
UP
or
DOWN
to set
the desired temperature.
•
When you touch
SET
again, the right LED indicator for LOWER ZONE will flash. Then proceed to touch the
UP
or
DOWN
to set the desired temperature for the LOWER ZONE.
•
The temperature will increase by 1°C or 1°F if you touch
UP
once, or the temperature will decrease by 1°C or
1°F if you touch
DOWN
once.
•
You can set the temperature by touching the
UP
and
DOWN
symbols. The display window will show the
setting temperature. When you touch the
UP
symbol and hold, the display window will temporarily flash the
inside temperature of UPPER ZONE and LOWER ZONE for 5 seconds.
NOTE:
When using the unit for the first time or after a long period of inactivity, there may be a variance of a few degrees between the
selected temperature and the temperature indicated on the LED readout. This is normal due to the length of inactivity, and will correct
itself after the unit is run for a few hours. If the unit is unplugged, has lost power or is turned off, wait 3 to 5 minutes before restarting the
unit. The unit will not restart before this time delay.
STORING WINE
While bottles may vary in size and dimension,
this wine cooler is designed for standard
Bordeaux 750ml bottles that are approximately
11.8 inches in length/height. You can place 77
standard bottles in the upper zone with 11 bottles
on each shelf and 78 standard bottles in the
lower zone with 11 bottles on each full-size shelf
and 6 bottles on each half-size shelf.
Approximate wine cooler capacity is 155 bottles.
NOTE:
When bottles on bottom shelf cannot be
longer than approximately 12 inches.
SHELVES
To avoid damaging the door gasket, ensure that the door is fully opened when pulling the shelves out of
the rail compartment.
•
The slide-out shelves allow bottles of wine
to be viewed and removed more easily.
Any of the shelves can be removed to
store larger bottles.
•
For easy access to the storage bottles,
you must pull the shelf approximately 1/3
out of the rail compartment, however this
unit was designed with a plastic post on
each side of the shelf track to prevent
bottles from falling.
•
When removing the shelf from the rail
compartment, make sure to remove all
items first. Then move the shelf to the
position where the notch of the shelf is
exactly under the plastic post and lift the
shelf. In order to replace the shelf, repeat
steps described above in reverse.
