Vimar Elvox K40960, User Manual

Page: 13 / 36

EN
13
K40960 - K40965
Installation
1) Using the key in the package, unscrew the anti-vandal screw on the bottom of the device (9).
2) Using a screwdriver, delicately lever along the edge of the bracket, near the side anchoring points (12): in this way,
the bracket (2) is released from the Wi-Fi video doorbell body.
3) perform the wiring of the cables to the terminals, taking care that you observe the connection order as specific in
point (17).
4) Screw the bracket to the wall, fixing firstly the upper hole and checking the correct vertical position, then finally the
bottom hole. To correctly position the Wi-Fi video doorbell, refer to the following figure at the bottom.
5) To store photos and videos taken with the device, check that the SD-card is inserted in the slot indicated in point
(16).
N.B. : if necessary, the sd-card should be inserted in the slot on the connectors side, with the connectors facing
the front of the Wi-Fi video doorbell.
6) Insert the terminal block in the related male connector and power up the device: it is now possible to connect it to
the VIEW Door App.
Below is the configuration procedure: we suggest you close the Wi-Fi video doorbell and tighten the closing
screw only once you have correctly connected the Doorbell to the App.
• Recommended height, unless different regulations are specified.
165 cm 120 cm