23
Villager
VTR 690B / VTR 695B (GB)
6.3.2 Replacing wheels
1. Place the machine on a flat surface and put
blocks under a load-bearing part of the frame on
the side of the wheel to be changed.
2. Using a screwdriver, remove the snap ring
(1)
and the washer
(2)
.
3. Pull out the wheel.
Smear some waterproof grease on the axle and after
refitting the wheel; carefully refit the washer (2) and the snap ring (1).
If you have to replace one or both rear wheels, make sure
that any differences in their external diameter does not exceed 8-10 mm; on the
contrary, to prevent an uneven
cut it will be necessary to adjust the alignment of
the cutting deck.
6.3.3 Replacing and repairing tires
All puncture repairs or replacements will have to be carried out by a tire repair
expert inaccordance with the methods for the kind of tire used.
6.3.4 Dismantling, replacing and remounting the blade
Always wear work gloves when handling the blade.
Damaged or bent blades must always be replaced; never try
to repair them! ALWAYS USE MANUFACTURER'S GENUINE REPLACEMENT BLADES
BEARING THE SYMBOL!
7. ENVIRONMENTAL PROTECTION
Environmental protection should be a priority of considerable importance when
using the machine, for the benefit of both social coexistence and the environment
in which we live.
- Try not to cause any disturbance to the surrounding area.
- Scrupulously comply with local regulations and provisions for the disposal of
waste.
Summary of Contents for VTR 690B
Page 79: ......
