Villager VLP 5420, Original Instruction Manual

Page: 43 / 224

19
Villager VLP 5420 (GB)
- Before operation, check that the switch is set in the required position. Do not
change the direction of rotation until the driver comes to a complete stop.
- When the driver is not in use move the direction switch to the neutral position
(the middle setting) to lock the trigger out.
Note: Failure to use the neutral position may activate the trigger inadvertently. This
inadvertent operation may cause the driver to become damaged.
VARIABLE SPEED TRIGGER – FIG. 6
When the trigger (3) is depressed, the
drive will rotate (provided the direction
switch (6) is set in the forward or reverse
position). This trigger switch is electronic
which enables the user to vary the speed
continuously.
-
The speed varies according to how far
the trigger switch is depressed.
- The further it is depressed, the faster
the drive spindle will rotate.
- The lighter it is depressed, the slower
it will rotate.
Note: If the fastening is heavily corroded,
or extremely tight, it may be necessary to
release the fixing by hand before
continuing with the driver.
BELT CLIP – FIG. 7
The belt clip (5) is convenient for hanging
the drill temporarily. The clip can be
installed on either side of the tool.
To install the clip:
-
Locate the clip (5) in position and
fasten with screw, take care to not
overtighten and strip the thread.
Fig. 8
Fig. 7
Fig. 6