Villager VLN 1760, Original Instruction Manual

Page: 20 / 88

Villager VLN 1760 (GB)
8
tool vertically (the drive spindle downwards), fill in the oil reservoir. Remove the oil gauge with
the spanner supplied, and watch out not to damage or lose the gasket. Fill the reservoir with
type 20 W 50 oil (motor oil). Place the gauge back.
Warning! Check oil level before every use. Check tightness of the oil cap. Oil leakage may occur
in case that oil cap is not enough tightened.
Oil leakage that happened when the oil cap is not enough tightened will not lead to device
’ s damage. If
oil leakage occur, you should clean machine with dry cloth and after that fill the oil in the oil reservoir
according to the procedure described in this user manual.
CHECKING OR CHANGING THE CARBON BRUSHES
These procedures are always done after the tool has been unplugged from the 230V network.
Checking the carbon brushes is advised after 50 hours of use of the tool. Remove the cover (J).
Remove the carbon-holder cap and remove the brush.
The carbon part should be at least 5mm long. In case of wear or in case of excessive sparks,
immediately change both brushes by carbon brushes with identical characteristics.
MAINTENANCE
Check the tightening of screws and nuts daily. Except for the procedures described in this
manual, this tool needs no particular
maintenance. The repair of the tool’s inner components is
should be performed by qualified professionals.
The cleaning of plastic parts is done with a soft damp cloth and a bit of mild soap. Never
submerge the tool and do not use detergents, alcohol, spirit, etc. For an in-depth cleaning,
please consult the after-sales department.
Warning: For maintenance and cleaning, always remove the plug from the electric power
supply. Never use water or other liquids to clean electric parts.
CAUTION:
Always make sure that the tool is switched off and unplugged before attempting to perform
inspection or maintenance.