Villager VLN 165, Original Instruction, Page: 31 / 96

11
Warning: Always disconnect the plug from the power source before making
any adjustment or attaching any accessories. Do not to use any abrasive
wheels.
1. Place this circular saw on its side on a flat surface. Advice you bring the base plate
down as if a minimum depth cut which is ease to operate.
2. Push the spindle lock button (15) toward motor housing as the arrow shows in Fig.
3 and firmly hold it.
3. Turn the blade clamp bolt (13) anti-clockwise by using the Allen key that supplied
with the tool.
4. Remove the blade clamp bolt and outer flange (12).
5. Raise the lower guard (14) by using the lever for lower guard (1), and then remove
the saw blade.
6. Clean the saw blade flanges, then mount the new saw blade onto the output
spindle and against the inner flange.
7. Make sure the saw teeth and arrow on the blade is to be the same direction as the
arrow on the lower guard.
8. Reinstall the outer flange, and tighten the blade clamp bolt.
9. Make sure that the saw blade runs freely by turning the blade by hand.
Depth adjustment
1.
Loosen the lock lever for depth adjustment (20).
Fig. 5