Villager VJS 3500, Original Instruction Manual

Page: 24 / 121

10
Villager VJS 3500 (GB)
USB power
Connect the USB device to the VJS 3500 with either the original cable or the
included multi-tip cable (better use original cable of Apple® for Apple® products).
Press Power button to start USB power. When disconnected, the VJS 3500 will
automatically shut off. The number of times you can recharge a USB device will
vary between devices.
Flashlight
Press and hold Power button for 3 seconds to start flashlight. Press once to switch
lighting modes: Steady On
– Strobe – SOS – Off.
Supply to 19V laptops
Select the appropriate input tip and connect the VJS 3500 with your laptop. Press
Power button to start 19V/3.5A power. When disconnected, the VJS 3500 will
automatically shut off. The number of times you can recharge a laptop will vary
between devices.
Supply to 12V devices
The VJS 3500 can run/charge 12V DC appliances that draw 10 amps or less. Connect
the VJS 3500 to 12V devices by the included accessory. Do not need press Power
button as the EC5 12V DC output is ALWAYS activated. When battery voltage of VJS
3500 is too low, 12V devices will stop running/charging.
Service
Leave the repair of the device to qualified technical personnel. Thus, the safety of
the device is guaranteed and maintained.
Caution!
Only qualified technical personnel should change the plug or the connecting cables.
This will guarantee the safety of the device is maintained. If the product is no
longer suitable for use dispose of it in an environmentally friendly manner in
accordance with your local ordinances.