Villager VJS 3500, Original Instruction Manual

Page: 21 / 121

7
Villager VJS 3500 (GB)
“BOOST” Mandatory Operations:
1) If with correct connection between Jump Starter and vehicle battery (Red LED
keeps on and green LED is off), press and hold BOOST button for 3 seconds
(after a buzzer sound, the green LED is on and red LED is off). Usually this is
because the vehicle battery capacity is rather low.
2) Start the engine (same method as the normal operations).
Cautions:
1) Under normal circumstances, do not use the mandatory operations.
2) The spark proof, reverse polarity protection and short circuit protection
features are disabled after Boost button is pressed. Pay very close attention to
the polarity of the battery before using this mode. Do not allow the positive and
negative battery clamps to touch or connect to each other as the item will
generate sparks and high heat if not used properly.
LED and Buzzer Communication:
No. Red LED Green LED Buzzer Sound Condition
1 On Off One sound
Jumper cable and EPS-300 are
connected.
2 Off On One sound
Jumper cable and vehicle
battery are connected.
Ready to start the engine.
3
Slow
flash
Off No buzzer
Lithium battery voltage in
EPS-300 is rather low.
4
Slow
flash
Off No buzzer
Have not turned on the ignition
switch within the regulated time.
To resolve this, you need remove
clamps from vehicle battery, and
connect again when No.1
condition occurs.
5 Fast flash Off Fast buzzer
Red and black clamps are
connected with each other.
6 Fast flash Off Fast buzzer
Reverse connection of
clamps.
7 Off Fast flash No buzzer Engine is started.
8 Off Fast flash No buzzer
Vehicle’s battery voltage is
higher than Jump Starter’s.