Villager VJS 2500, Original Instruction Manual

Page: 17 / 93

7
Villager VJS 2500 (GB)
Jump starting
1) This unit is only for emergency use, not for frequent commercial use! ENGINE
START socket is ALWAYS activated! Do not attempt to jumpstart your vehicle
when the EPS-101 battery capacity is below 25% (battery status indicator: 1
solid LED lit).
2) Turn off the vehicle ignition and all accessories (radios, lights, air conditioners,
etc.), and disconnect electronic devices.
3) Connect the jumper clamps to the correct polarity battery terminals.
4) Connect the EC5 plug of jumper cables to the ENGINE START socket of Villager
VJS 2500.
5) Try starting the vehicle (turn on the ignition switch). Most vehicles will
immediately start. Stop if the vehicle does not start after 5 seconds of engine
cranking. The jumpstart feature is designed for short term operation only, and
more than 5 seconds may cause damage to the unit. Allow the jump starter to
cool down for at least 3 minutes after each jumpstarting.
6) Disconnect the cable from the Villager VJS 2500 immediately after engine
starts, and then remove from battery terminals.
Charging
This product is partially charged from the manufacturer. Fully charge the unit
immediately after purchase. In order to prolong the product life, be sure to fully
recharge the unit after each jumpstaring, or every 3 months even if this unit has
not been used. If battery voltage in the Villager VJS 2500 is too low, this item will
shut off to prevent damage to itself. Recharge the unit as soon as possible to be
activated and fully charge it to ensure long battery life. In addition, we recommend
not to charge and discharge the unit at the same time.