Villager AGM EH 1505, Manual Instruction, Page: 33 / 135

AGM AGM EH 1505 (GB)
16
Inspection of tool
1.
Inspecting the tool
When using dull tool bits this can cause motor malfunction and degraded efficiency.
Always replace dull bits with new ones without delay when abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that they are properly tightened.
Should any of the screws be loose, retighten them immediately. Failure to do so
could result in serious injury.
3. Maintenance of the motor.
The motor unit winding is the very “heart” of the power tool. Exercise due care to
ensure the winding does not become damaged and/or wet with oil or water.
4. Inspecting the carbon brushes .
The motor employs carbon brushes that are consumable parts; since an excessively
worn carbon brush could result in motor trouble, replace the carbon brush. Always
keep carbon brushes clean and ensure that they slide freely within the brush
holders.
Maintenance and storage
Maintain your tool regularly. This will keep your tool in good working order and extend
its lifespan.
Do not use abrasive, caustic agents to clean the tool. These types of products will
damage your tool.
Do not perform repairs by yourself. Repairs and inspection must be carried out by a
competent person or at an authorized service center (please contact you service
dealer).
After each use
Check the blade, cable and body of the tool (cleanliness, wear, damage, etc.). If you
notice damage, wear, or malfunction, do not use the tool and bring it to a qualified
service for inspection and reparation.
Storage
After use and cleaning, please store your tool. Store the tool in a clean, dry place,
preferably in its box. During transport and storing always put the protection cover on
the blade. The tool must be stored away from children and pets. Avoid exposing the tool
to direct sunlight.