Villager AGM EH 1505, Manual Instruction, Page: 24 / 135

AGM AGM EH 1505 (GB)
7
•
Secure the work piece. Use tensioning equipment or a vice to secure the work
piece to help prevent kickback or uncontrolled flying of the work piece (e.g. when
getting jammed in the work piece).
•
Immediately switch off the power tool when the inserted tool becomes blocked.
Be prepared for high responses instances in the event of kickback.
The inserted
tool will jam when the power tool is overloaded or tilted within the work piece.
•
Never use the power tool with a damaged cable. Do not touch a damaged cable
and pull out the power plug immediately.
Damaged cables increase the risk of
electric shock.
•
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to jam and are easier to control.
•
Prevent overheating of the device and the work piece. Excess heat may damage
the tool and the device.
•
Shortly after being used, the tool may be very hot. Allow a hot tool to cool down.
Touching a hot tool may cause burns.
•
Never clean a hot tool with flammable liquids. There is a risk of fire and explosion.
•
Keep the handles dry and free of grease. Slippery handles can lead to accidents.
•
Always comply with the all applicable domestic and international safety, health and
working regulations.
Inform yourself before you start to work about regulations that
apply at the site of device.
•
Remember that moving parts may also be located behind ventilation and venting
slots.
•
Symbols affixed to your tools may not be removed or covered. Information on the
device that is no longer legible must be replaced immediately.
Risks caused by vibrations
CAUTION! Risk of injury due to vibrations! Vibrations may, in particular for
persons with circulation problems, cause damage to blood vessels and/or
nerves. If you notice any of the following symptoms, stop working
immediately and consult a doctor. Numbness of body parts, loss of sense of
feeling, itching, pins and needles, pain, changes in skin color.
The vibration values specified in the technical data represent the main uses of the device. The
actual existing vibrations during use may deviate from these as a result of the following factors:
•
Incorrect use of the product;
•
Unsuitable tools inserted;
•
Unsuitable material;
•
Insufficient maintenance.