Disassembly
© Viking Range Corporation
SMC-0002
15
Burner Valve
Shut off gas and electrical supply to unit.
1.
Remove knobs and insert (see Knobs and Insert
2.
procedure).
Remove screws securing control panel to main top.
3.
Remove ignition switch harness.
4.
Remove protective film over valve stems.
5.
Remove screw securing surface burner valve to
6.
manifold.
Replace component and reverse procedure to
7.
reassemble.
To avoid risk of electrical shock, personal injury, or death; disconnect power and shut off gas to unit before
servicing, unless testing requires power.
Igniters
Shut off gas and electrical supply to unit.
1.
Remove grate, burner cap and burner by lifting off of
2.
unit.
Remove 3mm hex screws securing burner base to
3.
main top assembly.
Lift burner base from main top assembly and
4.
disconnect igniter wire from igniter.
Replace component and reverse procedure to
5.
reassemble.
Burner Base
3mm Hex
Screws
Ignitor
Orifice
Burner
Burner Cap
Jet Holder
Orifices
Shut off gas and electrical supply to unit.
1.
Remove grate, burner cap and burner by lifting off of
2.
unit.
Remove 3mm hex screws securing burner base to
3.
main top assembly.
Lift burner base from main top assembly.
4.
Locate orifice inside venturi tube area.
5.
Remove orifice by turning counterclockwise.
6.
Replace component and reverse procedure to
7.
reassemble.
NOTE:
To obtain a better hold on the orifice when
removing it from a vertical location, line the
inside of the socket with tape.
