© 2012 Viking Preferred Service
43
Oven Thermostat Switch
To access oven thermostat switch:
1. Remove control panel
(see Control Panel
Disassembly)
.
2. Remove screws securing oven thermostat
switch to backer plate.
3. Reach into the opening and remove oven
thermostat switch and disconnect wiring.
4. Repair or replace oven thermostat switch as
necessary.
5. Reverse procedure to reinstall.
Note:
When replacing the thermostat switch take
note of the position when reinstalling. There is a
mark on the back of the switch to indicate the “TOP”
for orientation.
Clock
To access clock:
1. Remove control panel
(see Control Panel
Disassembly)
.
2. Remove screws securing clock to control
panel.
3. Repair or replace clock as necessary.
4. Reverse procedure to reinstall.
Note:
If replacing a ribbon cable,
the orientation of the plugs must
be the same. Hold both ends of
the ribbon cable side by side.
With the plugs in the same
orientation, verify that the red
marked side is the same on both
plugs. If the red mark is on the left on one plug and
the right on the other plug, this will not work and
could damage the relay boards.
Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit before servicing.
Wires removed during disassembly must be replaced on proper terminals to insure correct earth ground and
polarization. After servicing, reconnect electrical power.
