Viking RDSCE2305BSS, Installation Manual

Page: 7 / 14

13 12
General Information
READ AND FOLLOW ALL WARNING
AND CAUTION INFORMATION WHEN
INSTALLING THIS APPLIANCE.
• All openings in the wall behind the
appliance and in the floor under the
appliance must be sealed.
• DO NOT obstruct the flow of combustion
and ventilation air.
Moving, Handling, and Unpacking
Remove and discard all packing materials,
including cardboard and tape on the outside
and inside of the range.
Range – Do not discard the
anti-tip metal brackets (2)
supplied with the range.
These are the anti-tip devices
and one must be installed
with the unit.
Refer to
“Anti-tip Device Installation”
section.
Some stainless steel parts
may have a plastic protective
wrap which must be peeled
off. The interior should be washed
thoroughly with hot, soapy water to remove
film residues and any dust or debris before
being used, then rinsed and wiped dry.
Solutions stronger than soap and water are
rarely needed.
CAUTION
Avoid any damage to oven vents. The vents
need to be unobstructed and open to provide
proper airflow for optimal oven performance.
CAUTION
The cooling fan should be operating when
the unit is in operation. If you notice the
cooling fan is not operating or you observe
unusual or excessive noise coming from the
cooling fan, contact a Viking Authorized
Service Center before continuing operation.
Failure to do so can result in damage to the
oven or surrounding cabinets.
CAUTION
To avoid risk of personal injury or product
damages, DO NOT use the handle or
oven door to lift the oven. Remove door
before installation to ensure that it is not
used to lift the unit. DO NOT lift or carry
the door by the handle.
Removing the door must be done by your
dealer, or a qualified licensed plumber .
Door Removal
1
Open door completely. Place pins,
supplied with unit, in pin hole. For personal safety,
ONLY use pins supplied with the unit.
Backguard Installation
1
2
1
x4
Attach backguard to range with screws provided.
2
Remove hinge trim screws. Take off hinge trim. Identify
right and left hinge for future re-installation.
3
Close until pins stop door.
4
Lift door up and out.
Installation