23
22
1
Note:
Refer to range electrical
requirements section for proper
installation information.
Connect electrical in shaded area. See the “Electrical
Requirements” section for more information.
Final Installation
2
Slide range into place. Be sure anti-tip
bracket slides into the anit-tip opening.
3/
8”
3/8”
(0.
95
cm
)
(0.95 cm)
3/
8”
(0.
95
cm
)
3
Check that unit is level side to side
and front to back. The side trim must be 3/8” (0.95 cm)
above countertop. If unit is not level repeat steps 5-7
of “Leveling/Adjustments/Alignment” section.
1
1
2
2
3
2
Reattach door to range.
Open door completely. Reattach hinge trim.
3
4
Remove pins from hole in hinges.
Close door.
5
If the door needs to be adjusted, loosen hinge trim screws (see step 2).
Adjust the screws located between the door and kickplate using a 5/32”
hex head allen wrench. After adjustment, tighten hinge trim screws.
Door Replacement and
Adjustment
2
1
x2
3
Remove two screws from back of range.
1
2
4
Attach bracket to back of range using two screws.
5
Slide range into place and check that hook and bracket
are engaged.
Floor Mount Anti-tip Installation
(cont.)
Summary of Contents for RDSCE2305BSS
Page 14: ...27 26 ...
