Viking Oxeo, Installation And Maintenance Manual

Page: 116 / 238

Inst. and Maint. Manual | Oxeo PR LCP | F_101921 Rev 02 | 10-2022 | en
110
1. Adjusting spindle
2. Sealing wax
3. Setting range
2. Check whether the setting of the adjusting spindle corresponds to the delay time on the
enclosure. If necessary, reset the delay time (see “Checking the functioning of the pneumatic
time delay” on page 145.)
3. Check that the sealing wax is present and undamaged.
FIGURE 5-35: Assembling the time delay unit
1. Pressurized connection
2. Operating connection
3. Mounting bores
4. Firmly fix the time delay unit to the building in the correct installation position using the
two bores [Ø 0.18 in (4.5 mm)]. It can be fixed to a wall, support frame, or installation rail, for
example.
From a technical perspective, the time delay unit can be installed in any installation
position; however, the time delay relay must be assembled so that
•
the marking on the enclosure is visible
•
the setting range of the delay time is visible
•
the pneumatic pilot lines do not cross.