20
37. Call Button Delay
38. Call Button Auto Dial
The Call Button Delay is the length of time from when the Call button is pressed to when the unit starts dialing the
Primary number programmed in Phone Number Database Index 0. The time is programmable from 0 - 20 seconds.
Adding Call Button Delay time is useful to allow visitors time after they have pressed the Call button to then enter the
tenant’s apartment number (Speed Dial Number) or their Keyless Entry Code. Keyless codes can also be entered
without pressing the call button.
Factory Setting:
3 seconds
The Call Button Auto Dial feature allows visitors that do not know the tenant’s apartment number (Speed Dial Number)
a way of simply pressing the Call button with no additional numbers entered. After the Call Button Delay the unit will
automatically dial the Primary Phone Number stored in Phone Number Database Index 0. This could route the call to
the building manager, care taker, receptionist, etc.
Factory Setting:
Enabled
39. Mute Current / Next Alarm
A network failure alarm will be indicated by providing 3 beeps every 30 seconds. A network failure indicates the unit is
not registered to the SIP server or there is a communication failure with the gateway. The three beeps can be muted
by clicking on “Mute Current / Next Alarm”. The Status LED will continue to flash to assist troubleshooting. The alarm
beeps can also be permanently disabled. See Permanent Alarm Mute.
40. Permanent Alarm Mute
Selecting “Alarm Tones Disabled” will mute all alarm tones indefinitely. To re-enable alarm tones select “Alarm Tones
Enabled”.
Factory Setting:
Alarm Tones Enabled
36. In Call Dialing Format
The In Call Dialing Format can be set to In-Band DTMF (Touch Tones) or RFC 2833 (Out of Band DTMF Touch Tones). In
Call dialing refers to the numbers dialed (from the
K-1700-IP
’s keypad). after an outbound call has been answered by the
distant party. This would typically be the numbers dialed to steer through automated attendants, voice mail, etc. If your
VoIP phone system does not automatically convert out of band DTMF to In-Band after the call is answered, set In Call
Dialing Format to “Inband DTMF”.
Factory Setting:
RFC 2833
41. IP Firmware
If new
K-1700-IP
firmware is available, after opening the programming software a pop window will come up asking you
if you would like to update firmware. An alternative method of updating can be done by clicking the IP firmware “Update
IP” button. You can then browse to the folder that contains the PIP file for updating the unit’s IP firmware. This method
is typically only used when Viking Technical Support has sent you updated IP firmware.