39
Control Panel
DO NOT use any cleaners containing ammonia or abrasives.
They could
remove the graphics from the control panel. Use hot, soapy water and a soft
clean cloth.
Oven Surfaces
Several different finishes have been used in your electric oven. Cleaning
instructions for each surface are given below. The oven features a self-clean
cycle for the oven interior.
See the “Self-Clean Cycle” section for complete
instructions.
NEVER
USE AMMONIA, STEEL WOOL PADS OR ABRASIVE
CLOTHS, CLEANSERS, OVEN CLEANERS, OR ABRASIVE POWDERS. THEY
CAN PERMANENTLY DAMAGE YOUR OVEN.
Control Knobs
MAKE SURE ALL CONTROL KNOBS POINT TO THE “OFF” POSITION
BEFORE REMOVING. Pull the knobs straight off. Wash in detergent and
warm water. Dry completely and replace by pushing firmly onto stem.
Stainless Steel Parts
All stainless steel body parts should be wiped regularly with hot soapy water
at the end of each cooling period and with a liquid cleaner designed for
that material when soapy water will not do the job.
DO NOT
use steel wool,
abrasive cloths, cleansers, or powders. If necessary, scrape stainless steel to
remove encrusted materials, soak the area with hot towels to loosen the
material, then use a wooden or nylon spatula or scraper.
DO NOT
use a
metal knife, spatula, or any other metal tool to scrape stainless steel.
DO
NOT
permit citrus or tomato juice to remain on stainless steel surface, as citric
acid will permanently discolor stainless steel. Wipe up any spills immediately.
38
Cleaning and Maintenance
PP
rroo
dd
uu
cctt
CC
aa
rree
Problem
Cause
To Prevent
To Remove
Metal
markings
silver/gray
marks
Sliding or scraping
metal utensils on
glasstop.
Do not slide metal
objects across top.
Remove metal
marks before the
glasstop is used
again. Apply
cleaning creame
with a damp
paper towel and
scrub with a nylon
scrub pad or
brush. Rinse
thoroughly and
dry.
Hard water
spots
Condensation
from cooking may
cause minerals
found in water
and acids to drip
on glasstop and
cause gray
deposits. The
spots are often so
thin they appear
to be in or the
glasstop.
Make sure the
bottom of utensils
are dry before
cooking. Daily use
of cleaning
creame will help
keep top free from
hard water mineral
deposits and food
discoloration.
Mix cleaning
creame with water
and apply a thick
paste to stained
area. Scrub
vigorously. If stain
is not removed,
reapply cleaner
and repeat
process. Also try
cleaning
procedure for
smearing and
streaking.
Pitting or
flaking
Boil over of sugar
syrup on glasstop.
This can cause
pitting if not
removed
immediately.
Watch sugar and
syrups carefully to
avoid boilovers.
Turn element to
LO; using several
paper towels to
wipe the spill
immediately. Let
glasstop cool and
carefully scrape off
remainder of burn-
off with a single
edged razor held
at a 30° angle.
P
ro
d
u
ct
C
a
re
Cleaning Problems on Glass Ceramic Top
(cont.)
