2.
SET UP
13
CONNECT THE FOOT CONTROL
Among the accessories you will fi nd the
foot control cord and the main power cord.
Connecting the foot control cord to the foot
control is only necessary the very fi rst time
you are going to use the machine.
1. Take out the foot control cord. Turn the
foot control over. Connect the cord to
the socket inside the space of the foot
control.
2. Push
fi rmly to make sure it is properly
connected.
3. Lay the cord into the slot on the
underside of the foot control.
CONNECT TO THE POWER SUPPLY
On the underside of the machine you will
fi nd information about the power supply (V)
and the frequency (Hz).
Before plugging in the foot control, check
to ensure that it is of type “FR4/FR5” (see
underside of foot control).
1. Connect the foot control cord to the
front socket on the bottom right side of
the machine (A).
2. Connect the power cord to the rear
socket on the bottom right side of the
machine. (B)
3. When you press the power switch to ON
(C), both the machine and the light are
switched on.
Note: Your EMERALD™ sewing machine is
adjusted to provide the best stitch result at normal
room temperature. Extreme hot and cold temperatures
can affect the sewn result.
C
B
A
For USA and Canada
This sewing machine has a polarized plug
(one blade wider than the other). To reduce
the risk of electric shock, this plug is intended
to fi t in a polarized outlet only one way. If the
plug does not fi t fully in the outlet, reverse the
plug. If it still does not fi t, contact a qualifi ed
electrician to install the proper outlet. Do not
modify the plug in any way.
