41
40
4
5/16”
nut
driver
Attach canopy to duct cover/soffit. From inside of
hood, seal top of hood to duct with aluminum tape.
3
To install ventillation kit
refer to ventillation kit
installation instructions.
Run duct work down to bottom edge of duct
cover/soffit and secure in place. Make sure the duct
does not stick down past the cover.
1
2
3
5
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
2
1
3
6
Slide spacer front over front lip. Push spacer rear up,
then slide back over rear lip.
NOTE:
Number of spacers
and baffles may vary by model.
2
1
3
7
Slide filter front over front lip. Push filter rear up, then
slide back over rear lip.
Check framing where cutout will be.
NOTE:
200 lb. limit
.
Cut appropriate size hole in ceiling. Either 7” or 10”
depending on your specific unit and ventilator kit.
1
2
Mounting options:
Using duct cover with ceiling mounting
bracket. (Option A)
Using threaded rod for additional support.
(Option B)
Attaching hood to directly to soffit.
(Skip to step 3)
NOTE:
It is recommended to follow option
A or B, however both aren’t necessary.
Installation
(DCIH Classic Chimney Island Hoods)
A1
Attach duct cover to optional ceiling mounting bracket.
Attach duct cover to ceiling. The ceiling bracket can be
hidden by using a locally supplied trim.
A2
5/16”
nut
driver
B1
Additional support option. Drill holes in all four corners
for threaded rod and run rods from hood to ceiling.
