Care of your LED Fixture
Continued……
The Light has a Powercon in and out socket on the rear for easy daisy chaining of
units. The IN (Blue Socket & Plug) should be connected to the permanent 13a
mains supply whilst the OUT (White Socket & Plug) can be used to link to the
next unit in the chain. A maximum of 12 units cab be linked in this fashion. For
additional units an additional 13a mains feed will be required.
For protection of the Electronics an external 3.15a 20mm fuse is located on the
back panel. Please disconnect from the mains supply before re-fusing the unit.
When powered down the unit will remember it’s last setting as long as the Enter
button has been pressed to store the setting. If this is the case the unit will recommence
operation in the ‘saved’ mode on power up.
It is important to regularly clean the dust of the light, particularly in a permanent
lighting rig as the build up of considerable dust will impare the effectiveness
of the built in cooling fan.
The VK1810w is identical except it is IP65 rated. This rating means the light
cab be used outside in the wet. However it CANNOT be submersed in water.
Because it is IP65 rated the unit has trailing mains in and out connectors with
16a Mains connectors instead of the Powercon sockets. Also there is no
external fuse as this would degrade it’s IP status.
