6
downdraft Ventilators
viking range corporation
prepare tHe DoWnDraFt
Exterior Blower Installation
The downdraft is shipped without a blower. Purchase a Model
VEDV900 or VEDV200 Exterior Blower and mount the 10"
discharge plate to the downdraft as follows:
. Place the downdraft on its back on a table of flat work surface.
2. Remove the 4 nuts and 2 clamp channels.
3. Remove 2 screws and the gear motor cover.
4. Carefully position the0" discharge plate under the bottom
flange of the downdraft.
5. Connect motor plug.
6. Replace the gear motor cover and 2 sheet metal screws.
7. Replace the 2 clamp channels and start the 4 nuts, do not
tighten.
8. Slide blower left of right to desired position. Use cover plate
(supplied) to close up any open space.
9. Tighten 4 nuts to secure top of blower. Use additional screws
(supplied) through bottom flange to secure bottom of discharge
plate.
NUTS
COVER
PLATE
CLAMP
CHANNELS
SCREWS
GEARMOTOR
COVER
MOTOR
PLUG
0" ROUND
DISCHARGE
PLATE
ADDITIONAL
SCREWS
BOTTOM
FLANGE
cUt coUntertop opening
All Units
*
Must use island trim. Rear countertop trim (supplied with island trim) will be used in this installation.
. Measure and cut the countertop opening for your width of
cooktop and downdraft.
Cooktop Width & Model
30" VECU
36" VECU
30" VGSU
36" VGSU 30" VGRT * 36" VGRT * 48" VGRT *
For use with Downdraft Models
VIPR101SS
VIPR161SS
VIPR101SS
VIPR161SS
VIPR101RSS
VIPR161RSS
VIPR181RSS
VIPR101RSS VIPR161RSS
VIPR101RSS
VIPR161RSS
Cutout Dimensions
A
28-3/4"
34-3/4"
28-1/16"
34-1/4"
30"
36"
48"
B
20-1/4"
20-1/4"
18-3/4"
18-3/4"
24"
24"
24"
C
27"
33"
27"
33"
27"
33"
45"
D
2-1/4"
2-1/4"
3"
3"
2-3/4"
2-3/4"
2-3/4"
E
7/8"
7/8"
---
---
1-1/2"
1-1/2"
1-1/2"
F
7/8"
7/8"
1-1/16"
1-1/4"
1-1/2"
1-1/2"
1-1/2"
A
C
B
D
F
E
A
C
B
D
F
30" vgSU & 36" VGSU
cooktops onLY.